Top and bottom view - Note Tenon and Nut
The tenon is for mounting to a Scroll Chuck and the 3/4- 10 inserted nut in the tenon isfor mounting to a Live Center with removable cone or our OPTIONAL MT2 Chucky Arbor. See below for more information.
Original Rubber Chucky mounted in a 4 jaw Scroll Chuck
|
The Original Rubber Chucky was designed to use with Hollow Forms; but it can be used with any item you see fit. The dimensions of the Original Rubber Chucky are 4" at the base, tapering to a 1/2" diameter at the tip and 3 1/2" tall (the tenon height is not included in this dimension). These dimensions are approximate as each chucky is hand finished. We do recommend ordering the optional 3" MT2 Chucky Arbor to fully utilize this product. However, if you already own one of our Chucky MT2 Arbors, it will not be necessary to order another as it is interchangeable with all Rubber Chuckies. However, the arbor is necessary if you wish to turn a dovetail on the tenon.
NOTE: The Arbor has a 1/4" X 1" hole in the threaded end to accommodate items mounted on a 1/4" shaft such as sanding disks, buffs etc. It also has a 1/4-20 threaded hole in the taper end to install a draw bar. We offer a Chucky Drawbar Kit - for information Click Here |
The Left Arbor shows the 1/4-20 tapped hole for a draw bar, on the right is the 3" MT2 Chucky Arbor
Click Here for additional information on our Chucky MT2 Arbors
Original Rubber Chucky mounted in the headstock with a Chucky Arbor.
Original Rubber Chucky mounted on a Live Center with removable cone.
You must have a live center with a removable cone like the one shown below to mount to the tailstock.
Live Center, 60° Cone and Bar included.