The Bullet Chucky is used to hold almost any size opening (from 3/4” up to 1 3/4”) in a workpiece between centers.
It consists of two Bullet Chuckies that can be used individually or in conjunction or with any other Rubber Chucky.
Approximate sizes are 3.5” tall X 2” at base X 7/8” at tip
and 3.5” tall X 1 1/2” at base X 1/2” at tip.
The taper allows it to adjust to the odd size hole as we know that all of the holes we put in a workpiece are not exactly the same.
They can also be re-shaped to meet your turning requirements.
Also available with our MT2 Arbor.
Approximate sizes are 3.5” tall X 2” at base X 7/8” at tip
and 3.5” tall X 1 1/2” at base X 1/2” at tip.
The taper allows it to adjust to the odd size hole as we know that all of the holes we put in a workpiece are not exactly the same.
They can also be re-shaped to meet your turning requirements.
Also available with our MT2 Arbor.
You can even square off the end or make the end concave to accommodate your workpiece.
Some examples of Bullet Chuckies in use.
Mounted in Scroll Chuck and Live Center
Holding a Hollow From between centers.
Holding a Bird House Ornament with a Bullet Chucky and Drive Chucky for refinishing.
Bullet Chucky with MT2 Chucky Arbor and Scroll Chuck
Allowed for holding workpiece and not damaging the "fuzz" on the top.
Allowed for holding workpiece and not damaging the "fuzz" on the top.
