The sizes of these Vacuum Cones can be compared by looking at the Chucky Vacuum Cone the Large Chucky Vacuum Cone and the Micro Chucky Set (for the Micro Chucky Vacuum Set).
Save almost $10 by ordering the set of all three Vacuum Cones.
The Chucky Vacuum Cone Set is available in 1-8, 1 1/4-8 and M33 - 3.5 TPI Spindle Sizes.
The Micro Chucky Vacuum Set includes a MT2 Chucky VACUUM Arbor that is bored all the through allowing it to become a Vacuum Arbor. It can be used with any lathe that has a MT2 Spindle. If you already have a MT2 Chucky "VACUUM" arbor, you may order without it.
When ordering, the Spindle Size indicated will be for BOTH the Chucky Vacuum Cone and the Large Chucky Vacuum Cone. You may not order different size spindle sizes for one or the other.
This Set includes one each of the following:
Chucky Vacuum Cone
Large Chucky Vacuum Cone
Set of Micro Vacuum Chuckies and a MT2 Vacuum Arbor
(may be purchased without the VACUUM arbor if you already have one).
The Chucky Vacuum Cone Set is available in 1-8, 1 1/4-8 and M33 - 3.5 TPI Spindle Sizes.
The Micro Chucky Vacuum Set includes a MT2 Chucky VACUUM Arbor that is bored all the through allowing it to become a Vacuum Arbor. It can be used with any lathe that has a MT2 Spindle. If you already have a MT2 Chucky "VACUUM" arbor, you may order without it.
When ordering, the Spindle Size indicated will be for BOTH the Chucky Vacuum Cone and the Large Chucky Vacuum Cone. You may not order different size spindle sizes for one or the other.
This Set includes one each of the following:
Chucky Vacuum Cone
Large Chucky Vacuum Cone
Set of Micro Vacuum Chuckies and a MT2 Vacuum Arbor
(may be purchased without the VACUUM arbor if you already have one).
To utilize the Micro Vacuum Chucky you must have a vacuum system that DOES NOT utilize a lamp rod to hold the vacuum system in place. The Lamp Rod does work with the Chucky and Large Chucky Vacuum Cones but the end of the Lamp Rod will protude (not a good thing but still useable).There are adapters on the market available from other suppliers that are fine products and plug in to the wheel side of the headstock that will work with this product.
4/22/20 Due to the death of the person who manufactured the vacuum adapter shown below; we will be manufacturing our own in the near future. Ours is of a similar yet different design and will be available for many lathes. For further details please contact us at 248-877-0828.
They are far superior to the "Lamp Rod" system and only take seconds to install.
