- HARDWARE (Live Centers, Arbors, Extensions, Adapters, Etc.)
- >
- Chucky Drawbar Kit
Chucky Drawbar Kit
SKU:
$6.95
6.95
14.95
$6.95 - $14.95
Unavailable
per item
Kit consists of one 3" MT2 Arbor and one Retainer Disk ~ All thread Rod is NOT included.
DISCONTINUED!!
Sold out
The Chucky Drawbar kit is discontinued. You can still purchase the arbor in the Hardware section
The Chucky Buff Holders are available - but this page is not complete. More info coming soon! 8.25.15
Chucky Buff Holder
Our Drawbar Chucky Kit consists of the following.
A MT2 3" Buffing Arbor that has a 1/4" X 1" hole in the front end to accommodate buffing,sanding pads, etc.
It also has a 1/4-20 threaded hole in the taper end to accommodate a 1/4-20 all thread rod (not included but readily available at any hardware store) and a molded wing nut disk (included). You simply put the rod through your Headstock and cut the rod to length. Then screw the cut all thread into the arbor and install it in your headstock. Next install the molded wing nut onto the thread and tighten it up to the spindle to ensure the arbor is held in the spindle.
Chucky Buff Holder - All Thread rod NOT included
Chucky Buff Holder - Shown on outside of Headstock
Chucky Buff Holder installed on lathe.
Chucky Buff Holder with Sanding Cylinder
Chucky Buffs
Chucky Buffs are cotton and are available in the sizes and shapes shown below.
These buffs are mounted to a 1/4" diameter arbor and insert into the end of the Chucky Buff Holder.
All Chucky Buffs are cotton and are available in the sizes and shapes shown below.
Buffing Compounds
We offer three buffing compounds - Tripoli, White Diamond and Pure Beeswax. They may be purchased individually or as a combination package.
We recommend buffing first with theTripoli Compound followed by White Diamond Compound and with a finish buff of Beeswax.
Chucky Buff Holder
Our Drawbar Chucky Kit consists of the following.
A MT2 3" Buffing Arbor that has a 1/4" X 1" hole in the front end to accommodate buffing,sanding pads, etc.
It also has a 1/4-20 threaded hole in the taper end to accommodate a 1/4-20 all thread rod (not included but readily available at any hardware store) and a molded wing nut disk (included). You simply put the rod through your Headstock and cut the rod to length. Then screw the cut all thread into the arbor and install it in your headstock. Next install the molded wing nut onto the thread and tighten it up to the spindle to ensure the arbor is held in the spindle.
Chucky Buff Holder - All Thread rod NOT included
Chucky Buff Holder - Shown on outside of Headstock
Chucky Buff Holder installed on lathe.
Chucky Buff Holder with Sanding Cylinder
Chucky Buffs
Chucky Buffs are cotton and are available in the sizes and shapes shown below.
These buffs are mounted to a 1/4" diameter arbor and insert into the end of the Chucky Buff Holder.
All Chucky Buffs are cotton and are available in the sizes and shapes shown below.
Buffing Compounds
We offer three buffing compounds - Tripoli, White Diamond and Pure Beeswax. They may be purchased individually or as a combination package.
We recommend buffing first with theTripoli Compound followed by White Diamond Compound and with a finish buff of Beeswax.